Burst pipe? Keep clear of electrics, then stop the water.
A burst pipe needs prompt attention, but do not enter an unsafe area to reach a valve. Isolate the incoming water if safe, keep people away from electrical hazards and call for help.
Emergency prices include travel and the first hour of labour. Parts, materials and further labour are extra and agreed before proceeding.
The emergency sequence
- Keep people clear, then isolate the water if safe. The internal stopcock is often under the kitchen sink or where the supply enters. Turn gently clockwise without forcing it. Stored water and separate heating circuits may still discharge. If the valve is seized or inaccessible, call a plumber or your water supplier; do not operate a shared or unfamiliar boundary valve without their advice.
- Open a safe cold tap on the affected supply. After closing the stopcock, a low-level cold tap may help release remaining water. It does not guarantee that every tank or circuit is drained. Do not open hot-water drain valves or attempt to drain the heating system.
- Switch heating and water-heating controls off only if safe. Use normal, dry user controls that you can reach safely. Do not remove covers or disturb the boiler. Gas and boiler work is not currently offered by Ignite Plumbing; gas appliances require a Gas Safe registered engineer.
- Arrange electrical help where needed. Tell us about water near electrics when you call, and contact a qualified electrician or the electricity network emergency service as appropriate. Do not assume that a plumbing repair makes wet wiring safe.
- Contain water only from a safe position. Use towels or a bucket and move valuables only if there is no electrical or structural hazard. Stay out from under a sagging or bulging ceiling.
What we do when we arrive
- Assess the water-side fault and confirm appropriate isolation before plumbing work
- Explain the repair and agree any additional parts, materials or labour costs
- Repair or replace damaged pipework and inspect accessible nearby joints
- Restore and test the water supply when safe; electrical hazards require a qualified electrician
- Provide a record of the plumbing work; insurance cover and evidence requirements depend on your policy and insurer
Common questions
What is the first thing to do when a pipe bursts?
Keep clear of water near electrics and any bulging ceiling. If you can reach it safely, turn the internal stopcock gently clockwise without forcing it. This stops incoming mains water, but stored water or a separate heating circuit may still release water. Call a plumber and describe what is happening.
Should I open taps when a pipe bursts?
After isolating the mains, open a safely accessible cold tap on the affected supply, preferably low down, to release remaining water. This will not necessarily empty a loft tank, hot-water cylinder or heating circuit. Do not attempt to drain those systems yourself; ask for advice if you are unsure.
How much does a burst pipe emergency callout cost?
£130 including VAT from 7am to 10pm, or £190 including VAT from 10pm to 7am, including travel and the first hour of labour. Parts, materials and labour beyond the first hour are extra and agreed before proceeding. The 2-hour arrival guarantee is only for eligible phone-booked emergencies within 30 miles of Norwich, confirmed when the booking is accepted and subject to the published terms.
Is it safe to touch electrics after a burst pipe?
Do not touch wet switches, sockets, appliances or a wet consumer unit, and do not walk through water to reach electrical controls. Only turn off electricity if you can reach a dry main switch safely without entering the affected area. Otherwise keep away and seek urgent advice from a qualified electrician or your electricity network emergency service. A plumber's visit does not replace electrical safety checks. Call 999 if there is immediate danger to life.